Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › MASS AIR FLOW METER › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0403586 MASS AIR FLOW METER G

N04C-WA ENGINE CONTROL  MASS AIR FLOW METER  INSPECTION  


PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.
A154164C13
1.25,0.865 1.063,0.865 1.063,0.865 0.917,2.052 true 1.281,0.771 1.615,1.083 0.333,0.313 10 false *a
*a Platinum Filament (Heater)


Using a work light, check that the platinum filament (heater portion) and temperature sensing element in the mass air flow meter has no foreign matter attached.

OK:

No foreign matter attached.


If the result is not as specified, replace the mass air flow meter.


b.
A127786C12
2.927,1.448 2.927,0.729 2.927,0.729 3,0.729 true 2.781,1.458 2.583,0.729 2.583,0.729 2.448,0.729 true 2.177,0.646 2.417,0.813 0.24,0.167 10 false E2 3.031,0.646 3.365,0.802 0.333,0.156 10 false THA 0.042,0.042 0.229,0.219 0.188,0.177 10 false *a
*a Component without harness connected (Mass Air Flow Meter)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition

If the result is not as specified, replace the mass air flow meter.

1 (THA) - 2 (E2) -20°C (-4°F) 13.6 to 18.4 kΩ
20°C (68°F) 2.21 to 2.69 kΩ
60°C (140°F) 0.49 to 0.67 kΩ