Home › Engine / Hybrid System › N04C-WA (ENGINE CONTROL) › NITROGEN OXIDES SENSOR › from 2019.08
RM2850E _51 Engine / Hybrid System _082611 N04C-WA ENGINE CONTROL _0403593 NITROGEN OXIDES SENSOR A

N04C-WA ENGINE CONTROL  NITROGEN OXIDES SENSOR  INSTALLATION  


PROCEDURE

Hide 89463D 1.INSTALL NO. 2 NITROGEN OXIDES SENSOR

a.
A450263C01
0.896,1.667 1.052,1.667 1.052,1.667 1.292,0.927 true 2.26,0.469 2.479,0.646 0.219,0.177 10 true *a 0.573,1.583 0.927,1.771 0.354,0.188 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the No. 2 nitrogen oxides sensor.

SST
09224-00012  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 44.7 N*m (456 kgf*cm, 33 ft.*lbf)




b.

Connect the No. 2 nitrogen oxides sensor with the 2 bolts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


c.

Connect the connector to the No. 2 nitrogen oxides sensor.


d.

Attach the 3 clamps.


Hide 89463C 2.INSTALL NO. 1 NITROGEN OXIDES SENSOR

a.
A450262C01
0.917,1.219 1.073,1.219 1.073,1.219 1.75,0.781 true 2.74,0.656 2.927,0.833 0.188,0.177 10 true *a 0.563,1.125 0.917,1.333 0.354,0.208 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the No. 1 nitrogen oxides sensor.

SST
09224-00012  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 44.7 N*m (456 kgf*cm, 33 ft.*lbf)




b.

Connect the No. 1 nitrogen oxides sensor with the 2 bolts.

Torque:
12.5 N*m (127 kgf*cm, 9 ft.*lbf)


c.

Connect the connector to the No. 1 nitrogen oxides sensor.


d.

Attach the 4 clamps.