Only refill with urea solution (AdBlue) (compliant with ISO 22241-1).
If urea solution (AdBlue) comes into contact with any painted surfaces on the vehicle, immediately wash the affected areas with water.
1.REFILL UREA SOLUTION (AdBlue)
Connect the GTS to the DLC3.
Turn the ignition switch on.
Turn the GTS on.
Enter the following menus: Powertrain / Urea Selective Catalytic Reduction / Data List / Reductant Tank Level Sensor Voltage.
Inspect the add capacity of the urea solution (AdBlue).
Approximately 23.0 liters (24.3 US qts, 20.2 Imp. qts)
| Reductant Tank Level Sensor Voltage | Specified Condition |
|---|---|
| 4.64 to 4.72 V | Approximately 22.2 to 23.0 liters (23.5 to 24.3 US qts, 19.5 to 20.2 Imp. qts) |
| 4.50 to 4.60 V | Approximately 19.2 to 22.1 liters (20.3 to 23.4 US qts, 16.9 to 19.4 Imp. qts) |
| 4.28 to 4.39 V | Approximately 16.2 to 19.1 liters (17.1 to 20.2 US qts, 14.3 to 16.8 Imp. qts) |
| 3.94 to 4.05 V | Approximately 13.2 to 16.1 liters (13.9 to 17.0 US qts, 11.6 to 14.2 Imp. qts) |
| 3.39 to 3.52 V | Approximately 10.3 to 13.1 liters (10.9 to 13.8 US qts, 9.1 to 11.5 Imp. qts) |
| 2.81 to 2.95 V | Approximately 7.5 to 10.2 liters (7.9 to 10.8 US qts, 6.6 to 9.0 Imp. qts) |
| 2.21 to 2.35 V | Approximately 4.8 to 7.4 liters (5.1 to 7.8 US qts, 4.2 to 6.5 Imp. qts) |
| 1.58 to 1.70 V | Approximately 2.5 to 4.7 liters (2.6 to 5.0 US qts, 2.2 to 4.1 Imp. qts) |
| 0.92 to 1.01 V | Approximately 0 to 2.4 liters (0 to 2.5 US qts, 0 to 2.1 Imp. qts) |
The level display of the urea solution slightly differs such as the urea solution (AdBlue) decreasing due to driving, or increasing due to refilling.
The remaining amount of urea solution (AdBlue) is the value when the urea tank assembly is parallel to the ground.
Disconnect the GTS from the DLC3.
Remove the urea tank cap assembly.
| *a | F line (Refill Check Tube Side) |
| *b | F line (Urea Tank Sub-assembly Side) |
While checking the refill check tube side, refill the urea solution (AdBlue) to the F line.
If urea solution (AdBlue) comes into contact with any painted surfaces on the vehicle, immediately wash the affected areas with water.
Install the urea tank cap assembly.