1.CHECK ENGINE OIL LEVEL
Warm up the engine, then stop the engine and wait for 5 minutes.
Check that the engine oil level is between the low level and full level marks on the oil dipstick. If low, check for leakage and add oil up to the full level mark.
Do not fill with engine oil to above the full level mark.
A certain amount of engine oil will be consumed while driving. In the following situations, oil consumption may increase, and engine oil may need to be refilled in between oil maintenance intervals.
When the engine is new, for example directly after purchasing the vehicle or after replacing the engine.
If low quality oil or oil of an inappropriate viscosity is used.
When driving at high engine speed or with a heavy load, (when towing, or), when driving while accelerating or decelerating frequently.
When idling for a long time, or when driving frequently through heavy traffic.
When judging the amount of oil consumption, keep in mind that the oil may have become diluted, making it difficult to judge the true level accurately.
2.INSPECT OIL PRESSURE
| *1 | Engine Oil Pressure Switch Assembly |
| *a | Union Bolt |
| *b | Gasket |
| *c | Union |
| *d | Adapter |
| *e | Oil Pressure Gauge |
Remove the engine oil pressure switch assembly.
Click hereEngine / Hybrid System>N04C-VL (LUBRICATION)>OIL PRESSURE SWITCH>REMOVAL
Install the union and 2 new gaskets to the oil cooler cover sub-assembly with the union bolt.
| Union bolt | 90034-01011 |
| Union | 90404-10024 |
Install the oil pressure gauge.
Warm up the engine.
Inspect the oil pressure.
| Engine condition | Specification |
|---|---|
| When Idling | 190 kPa (1.9 kgf/cm2, 27.6 psi) |
Remove the oil pressure gauge.
Remove the union and union bolt.
Install the engine oil pressure switch assembly.
Click hereEngine / Hybrid System>N04C-VL (LUBRICATION)>OIL PRESSURE SWITCH>INSTALLATION