Home › Suspension › REAR SUSPENSION › REAR STABILIZER BAR › from 2019.08
RM2850E _53 Suspension _073450 REAR SUSPENSION _0357521 REAR STABILIZER BAR G

REAR SUSPENSION  REAR STABILIZER BAR  INSPECTION  


PROCEDURE

Hide 48840A 1.INSPECT REAR STABILIZER LINK ASSEMBLY LH

a.
C369533

As shown in the illustration, move the ball joint stud back and forth 5 times before installing the nut.


b.

Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and take the torque reading on the fifth turn.

Turning torque:
for Super Long Wheelbase:

0.5 to 3.4 N*m (5.1 to 34.6 kgf*cm, 4.5 to 30.0 in.*lbf) or less

except Super Long Wheelbase:

0.05 to 1.96 N*m, (0.6 to 19.9 kgf*cm, 0.5 to 17.3 in.*lbf) or less



c.

Check for any cracks and grease leaks on the ball joint dust cover.