15100
1.INSPECT OIL PUMP ASSEMBLY
Visually check each part of the oil pump assembly for damage or wear.
If damage or wear is excessive, replace the oil pump assembly with a new one.
Inspect the clearance between the oil pump drive gear and cylinder block.
Using a vernier caliper, measure the length of the oil pump drive gear.
27.02 to 27.04 mm (1.0638 to 1.0646 in.)
Using a vernier caliper, measure the depth of the cylinder block.
27.027 to 27.067 mm (1.0641 to 1.0656 in.)
Add the measurement of the cylinder block to the thickness of the gasket. From this total, subtract the measurement of the oil pump drive gear.
0.047 to 0.147 mm (0.00185 to 0.00579 in.)
0.17 mm (0.00669 in.)
If the clearance is greater than the maximum, replace the oil pump assembly or cylinder block.
Inspect the backlash between the oil pump drive gear and oil pump driven gear.
Using a vise, fix the oil pump assembly.
Using a dial indicator, measure the backlash between the oil pump drive gear and oil pump driven gear.
0.137 to 0.302 mm (0.00539 to 0.0119 in.)
0.302 mm (0.0119 in.)
If the backlash is greater than the maximum, replace the oil pump assembly with a new one.
Inspect the clearance between the oil pump drive gear shaft and oil pump drive gear bush.
Using a micrometer, measure the diameter of the oil pump drive gear shaft.
18.088 to 18.106 mm (0.7121 to 0.7128 in.)
Using a dial indicator, measure the inside diameter of the oil pump drive gear bush.
18.146 to 18.187 mm (0.7144 to 0.7160 in.)
Subtract the diameter measurement of the oil pump drive gear shaft from the inside diameter measurement of the oil pump drive gear bush.
0.040 to 0.099 mm (0.00157 to 0.00390 in.)
0.13 mm (0.00512 in.)
If the clearance is greater than the maximum, replace the oil pump assembly or drive gear bush.
Inspect the clearance between the oil pump driven gear shaft and oil pump driven gear bush.
Using a micrometer, measure the diameter of the oil pump driven gear shaft.
17.979 to 17.997 mm (0.7078 to 0.7085 in.)
Using a dial indicator, measure the inside diameter of the oil pump driven gear bush.
18.037 to 18.054 mm (0.7101 to 0.7108 in.)
Subtract the diameter measurement of the oil pump driven gear shaft from the inside diameter measurement of the oil pump driven gear bush.
0.040 to 0.075 mm (0.00157 to 0.00295 in.)
0.13 mm (0.00512 in.)
If the clearance is greater than the maximum, replace the oil pump driven gear or oil pump cover sub-assembly.