When the ignition switch is turned ON, battery voltage is applied to terminal IG of the TCM.
Inspect the fuses for circuits related to this system before performing the following procedure.
Disconnect the TCM connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| B79-1 (IG) - B79-2 (E) | Ignition switch ON | 11 to 14 V |
| *a | Rear view of wire harness connector
(to TCM) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| B79-2 (E) - Body ground | Always | Below 1 Ω |
| *a | Rear view of wire harness connector
(to TCM) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the 2C No. 2 integration relay connector.
Disconnect the B79 TCM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2C-8 - B79-1 (IG) | Always | Below 1 Ω |
| 2C-8 or B79-1 (IG) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the No. 2 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2C-7 - Body ground | Always | Below 1 Ω |
| *a | Front view of wire harness connector
(to No. 2 Integration Relay) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the No. 2 integration relay (IG2 relay) (Click hereEngine / Hybrid System>N04C-UH (ENGINE CONTROL)>RELAY>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the No. 2 integration relay connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2E-1 - Body ground | Always | 11 to 14 V |
| *a | Front view of wire harness connector
(to No. 2 Integration Relay) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the ignition switch (Click hereEngine / Hybrid System>N04C-UH (STARTING)>IGNITION SWITCH(w/ Tilt Steering Column)>INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereEngine / Hybrid System>N04C-UH (STARTING)>IGNITION SWITCH(w/ Tilt Steering Column)>REMOVAL