Home › General › SPECIFICATIONS › N04C-WA EMISSION CONTROL › from 2019.08
RM2850E _V1 General _073185 SPECIFICATIONS _0404904 N04C-WA EMISSION CONTROL F

SPECIFICATIONS  N04C-WA EMISSION CONTROL  SERVICE DATA  


EXHAUST GAS TEMPERATURE SENSOR
Tester Connection Condition Specified Condition
1 - 2 When racing engine
(increasing exhaust gas temperature)
Resistance starts to decrease

EXHAUST FUEL ADDITION INJECTOR
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 7.1 to 7.9 Ω

FUEL PRESSURE SENSOR
Tester Connection Condition Specified Condition
2 (PR) - 1 (E2) Pressure not applied to No. 2 fuel pressure sensor Approximately 0.38 to 0.62 V*

*: The output voltage changes depending on the voltage applied to the terminals.

DIFFERENTIAL PRESSURE SENSOR
Tester Connection Condition Specified Condition
V70 (PEX) - M32 (E2) 0 kPa 0.75 V
20 kPa (0.2 kgf/cm2, 3 psi) 1.53 V
100 kPa (1.0 kgf/cm2, 15 psi) 4.65 V

DPR SWITCH ASSEMBLY
Tester Connection Condition Specified Condition
1 (E) - 4 (B) Not pushed 10 kΩ or higher
Pushed Below 1 Ω

UREA INJECTOR
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 11.6 to 12.4 kΩ

UREA PUMP
Item Tester Connection Condition Specified Condition
Level sensor 14 (LVU) - 6 (ELU) Float is up 118.82 to 121.55 kΩ
14 (LVU) - 6 (ELU) Float is down 1.40 to 1.46 kΩ
Tank heater 9 (HTT) - 11 (EHTT) 25°C (77°F) 1.36 to 1.52 kΩ
Temperature sensor 1 (THU) - 2 (ETHU) 20°C (68°F) 2.47 to 2.56 kΩ
1 (THU) - 2 (ETHU) 30°C (86°F) 1.69 to 1.75 kΩ
Pump motor 7 (UPMU) - 8 (UPMV) 20 to 30°C (68 to 86°F) 0.35 to 0.43 Ω
7 (UPMU) - 16 (UPMW) 20 to 30°C (68 to 86°F) 0.35 to 0.43 Ω
8 (UPMV) - 16 (UPMW) 20 to 30°C (68 to 86°F) 0.35 to 0.43 Ω
7 (UPMU) - 15 (MGND) Always 10 kΩ or higher
8 (UPMV) - 15 (MGND) Always 10 kΩ or higher
16 (UPMW) - 15 (MGND) Always 10 kΩ or higher

UREA TUBE
Item Tester Connection Condition Specified Condition
Urea tube wuth heater assembly (Front) 1 - 2 25°C (77°F) 1.00 to 1.24 Ω
Urea tube wuth heater assembly (Rear) 1 - 2 25°C (77°F) 1.57 to 1.93 Ω