Home › Engine / Hybrid System › N04C-WA (STARTING) › STARTER › from 2019.08
RM2850E _51 Engine / Hybrid System _082619 N04C-WA STARTING _0406101 STARTER A

N04C-WA STARTING  STARTER  DISASSEMBLY  


PROCEDURE

Hide 28140 1.REMOVE STARTER BRUSH HOLDER ASSEMBLY

a.
A161624E03
0.917,0.667 1.083,0.667 1.083,0.667 1.406,0.594 false 0.75,0.594 0.917,0.74 0.167,0.146 10 false *a

Remove the nut from terminal C.

Text in Illustration
*a Terminal C


b.

Remove the 2 through bolts and 2 screws, then pull the commutator end frame from the starter yoke assembly.


c.

Remove the dust protector from the commutator end frame.


d.
A161625E01
1.667,0.906 2.052,0.198 2.052,0.198 2.219,0.198 false 1.927,1.177 2.083,1.76 2.083,1.76 2.25,1.76 false 2.24,0.104 2.469,0.333 0.229,0.229 10 false *a 2.271,1.667 2.5,1.896 0.229,0.229 10 false *b

Using a screwdriver, hold the starter brush spring back and disconnect the 4 starter brushes from the starter brush holder assembly.

Text in Illustration
*a Starter Brush Spring
*b Starter Brush


e.

Remove the starter brush holder assembly from the starter armature assembly.


Hide 28120 2.REMOVE STARTER YOKE ASSEMBLY

a.
A161659

Remove the starter yoke assembly.


b.

Remove the 2 rubber seals.


Hide 28160 3.REMOVE STARTER ARMATURE ASSEMBLY

a.
A161627

Remove the starter armature assembly from the magnet starter switch assembly.


Hide 28256 4.REMOVE STARTER INTERNAL GEAR

a.
A161628

Remove the starter plate.


b.
A161629

Remove the starter washer.


c.
A161630

Remove the 3 starter planetary gears.


d.
A161631

Remove the starter internal gear.


Hide 28213 5.REMOVE STARTER CLUTCH PINION

a.
A163699E05
1.552,0.156 1.729,0.156 1.729,0.156 2.365,0.719 false 1.344,0.073 1.51,0.25 0.167,0.177 10 false *a

Using a snap ring pliers and screwdriver with its tip wrapped with protective tape, remove the retainer.

Text in Illustration
*a Protective Tape


b.

Remove the pinion stop nut, starter clutch pinion and starter drive spring.


Hide 28110 6.REMOVE STARTER DRIVE HOUSING ASSEMBLY

a.
A161632

Remove the 2 bolts and starter drive housing assembly from the magnet starter switch assembly.


Hide 28011 7.REMOVE STARTER CLUTCH SUB-ASSEMBLY

a.
A161633

Using a snap ring pliers, remove the snap ring.


b.

Remove the pinion drive lever and 3 starter washers.


c.

Remove the starter clutch sub-assembly from the magnet starter switch assembly.