Wear protective gloves. Sharp areas on the parts may injure your hands.
1.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
2.REMOVE NO. 1 SEAT CUSHION COVER WITH PAD
Disconnect the connector and detach the clamp.
Detach the fastening tape and fold up the No. 1 seat cushion cover sub-assembly RH.
Detach the 5 hooks and remove the No. 1 seat cushion cover with pad from the seat frame.
79015A
3.REMOVE NO. 1 SEAT CUSHION PAD SUB-ASSEMBLY RH (OCCUPANT DETECTION SENSOR)
| *a | Fastening Tape |
| *b | Band |
Detach the fastening tape and band.
Remove the 8 hog rings and No. 1 seat cushion cover RH from the No. 1 seat cushion pad sub-assembly RH (occupant detection sensor).