DPF FORCIBLE REGENERATION PROCEDURE
Park the vehicle in a safe location.
Do not leave combustible materials around the exhaust pipe because the temperature of the DPF catalytic converter increases during the forcible regeneration.
Shift the lever to the neutral position.
Securely apply the parking brake.
Warm up the engine.
The water temperature is 75°C (167°F) or more.
Accelerate the engine speed to the maximum rpm with no load 5 times.
Connect the GTS to the DLC3.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Activate the DPF Rejuvenate (PM)
When the DPF indicator light is blinking, the forcible regeneration function can be performed by pressing the DPF switch.
Check that the idling speed increases and the exhaust brake operates.
While the forcible regeneration is performed, monitor the exhaust gas temperature, and stop the forcible regeneration when temperature reaches 800°C (1472°F) or higher. In this case, disassemble the catalytic converter and blow air to the oxidation catalyst and DPF catalyst from their rear sides, and perform the forcible regeneration again.
If DTC P2463 recurs during the forcible regeneration, catalyst degradation may occur.
While performing the forcible regeneration, sometimes the exhaust brake does not close or it repeats closing and opening. If the forcible regeneration is successfully completed, such phenomena should not be taken as a malfunction.
It takes 15 to 25 minutes to complete the forcible regeneration function.
Check that the engine speed decreases, the exhaust brake is released, and the forcible regeneration function is completed.
After the forcible regeneration is completed, allow the engine to idle for at least 5 minutes.
Enter the following menus: Powertrain / Engine and ECT / Exhaust Temperature B1S1.
Enter the following menus: Powertrain / Engine and ECT / Data List / DPF Differential Pressure.
Check the differential pressure when the exhaust gas temperature sensor indicates 200°C or less.
15 kPa or less.
If the exhaust gas temperature is high, the differential pressure cannot be measured correctly.
If the differential pressure is outside the normal range, the monolithic converter assembly may have deteriorated or the monolithic converter assembly may be clogged with PM.
Fully depress the accelerator pedal and when the engine speed becomes stable, promptly read the differential pressure.
Check the amount of engine oil.
If the amount of engine oil is more than the specified level, replace the engine oil.
DPF FORCIBLE REGENERATION is complete.