Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › ECD SYSTEM › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454116 ECD SYSTEM D

N04C-VJ ENGINE CONTROL  ECD SYSTEM  CHECK MODE PROCEDURE  


HINT:

Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect the same malfunctions that normal mode can.

In check mode, the ECM will detect faults and set DTCs more effectively than in normal mode.


NOTICE:

All the stored DTCs and freeze frame data are erased if: 1) the ECM is changed from normal mode to check mode or vice versa; or 2) the ignition switch is turned from ON to ACC or OFF during check mode.

Before changing modes, always check and note any stored DTCs and freeze frame data.


CHECK MODE PROCEDURE


a.

Turn the ignition switch off.


b.

Make sure that the vehicle is in the following conditions:

i.

Battery voltage is 11 V or more.


ii.

Accelerator pedal is not depressed.


iii.

Parking brake is released.


iv.

Shift lever is in neutral.


v.

A/C switch is off.



c.

Connect the GTS to the DLC3.


d.

Turn the ignition switch to ON.


e.

Turn the GTS on.


f.

Enter the following menus: Utility / Check Mode.


g.
A076900E72
2.042,0.417 2.948,0.646 0.906,0.229 10 0.13 seconds 1.917,1.833 2.823,2.063 0.906,0.229 10 0.13 seconds 0.135,0.76 0.427,0.958 0.292,0.198 10 ON 0.135,1.385 0.427,1.583 0.292,0.198 10 OFF

Make sure that the MIL flashes as shown in the illustration.


h.

Start the engine (the MIL should turn off).


i.

Simulate the conditions of the malfunction described by the customer.


j.

Check the DTC(s) and freeze frame data using the GTS.


k.

After checking for DTCs, inspect the appropriate circuits (Click hereEngine / Hybrid System>N04C-VJ (ENGINE CONTROL)>ECD SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).