This DTC is stored when the engine coolant temperature becomes abnormally high due to the radiator being clogged, the thermostat being blocked, etc.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | MIL | Memory |
|---|---|---|---|---|---|
| P0217 | Engine Coolant Over Temperature Condition | The engine coolant temperature is 115°C (239°F) or higher for 30 seconds or more while the engine is running and the battery voltage is 8 V or higher.
(1 trip detection logic) |
·
Radiator assembly ·
Thermostat ·
Engine coolant routing line ·
Water pump ·
Engine coolant failure ·
ECM |
Does not come on | DTC stored |
| DTC No. | DTC Detection Drive Pattern |
|---|---|
| P0217 | After warming up, drive at an engine speed of 1000 rpm or higher and 10 km/h or higher. |
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, as well as other data recorded at the time of a malfunction.
When confirming the freeze frame data, be sure to check all 5 sets of freeze frame data.
The fourth set of freeze frame data is the data recorded when the DTC is stored.
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
|---|---|
| DTC P0217 is output | A |
| DTC is not output | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Record the stored DTCs and freeze frame data.
Freeze frame data shows the actual engine conditions when engine starting trouble occurred.
| Proceed to |
|---|
| NEXT |
NEXT
Inspect the cooling system (Click hereEngine / Hybrid System>N04C-VJ (COOLING)>COOLING SYSTEM>ON-VEHICLE INSPECTION).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Inspect the engine assembly (Click hereEngine / Hybrid System>N04C-VJ (ENGINE MECHANICAL)>ENGINE>ON-VEHICLE INSPECTION).
| Proceed to |
| NEXT |
NEXT