Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › ECD SYSTEM › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0454116 ECD SYSTEM C

N04C-VJ ENGINE CONTROL  ECD SYSTEM  P1530  Engine Emergency Halt Switch  


DESCRIPTION

Some vehicles are equipped with an emergency halt switch due to the conversion of the vehicle. In this case, this DTC is stored if a vehicle speed signal and emergency halt switch ON signal are input to the ECM simultaneously. If this DTC is stored, inspect and repair the emergency halt switch circuit.

HINT:

Different types of emergency halt switches may be used according to the type of vehicle conversion.


DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory
P1530 Engine Emergency Halt Switch Both of the following conditions (1) and (2) are met (1 trip detection logic):

(1) Engine speed 10 km/h (6.3 mph) or more

(2) STOP signal on


·

Emergency halt switch circuit

·

Emergency halt switch

·

ECM


Does not come on DTC stored

CONFIRMATION DRIVING PATTERN

DTC No. DTC Detection Drive Pattern
P1530 Engine speed 10 km/h (6.3 mph) or more

PROCEDURE

1.CLEAR DTC
a.

Connect the GTS to DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.



Result:
Proceed to
NEXT



NEXT

2.CHECK WHETHER DTC OUTPUT RECURS
2.CHECK WHETHER DTC OUTPUT RECURS
a.

Turn the ignition switch off, and wait for 15 seconds.


b.

Connect the GTS to DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.


f.

Read the DTCs.

Result:
Result Proceed to
DTC P1530 is output A
DTC is not output B




A

CHECK AND REPLACE EMERGENCY HALT SWITCH CIRCUIT

B