35106
1.REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY
35330
2.REMOVE VALVE BODY OIL STRAINER ASSEMBLY
Remove the 3 bolts and valve body oil strainer assembly.
3.REMOVE TRANSMISSION WIRE
Disconnect the 16 connectors.
Use a new transmission wire if the pin and socket terminal of the oil-pressure terminal has been removed.
Stretch the cable clamp by hand as shown in the illustration and disconnect the transmission wire.
Disconnect the No. 2 transmission wire connector.
Disconnect the No. 1 transmission wire connector.
| *a | Protective Tape |
Remove the bolt and using a screwdriver with its tip wrapped in protective tape, pull out the No. 2 transmission wire from the transmission case subassembly.
| *a | Protective Tape |
Remove the bolt and using a screwdriver with its tip wrapped in protective tape, pull out the No. 1 transmission wire from the transmission case subassembly.