1.REMOVE REAR WHEEL
2.REMOVE SKID CONTROL SENSOR WIRE
Remove the bolt and detach the 4 clamps.
Disconnect the connector.
Remove the bolt and disconnect the speed sensor bracket.
Remove the bolt.
| *a | for Type A | *b | for Type B |
for Type A:
Detach the guide and disconnect the connector.
for Type B:
Disconnect the connector.
Detach the 3 clamps and disconnect the connector.
Remove the skid control wire from the body.
3.REMOVE REAR SPEED SENSOR LH
Remove the bolt and rear speed sensor LH.
Prevent foreign matter from attaching to the sensor tip.
4.REMOVE REAR SPEED SENSOR RH
Use the same procedure described for the LH side.