1.INSPECT BRAKE PEDAL LOAD SENSING SWITCH
Do not remove the brake pedal load sensing switch from the brake pedal lever subassembly.
When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal lever sub-assembly.
Disconnect the brake pedal load sensing switch connector.
| *1 | Brake Pedal Load Sensing Switch | - | - |
| *a | Brake pedal released (ON) | *b | Brake pedal depressed (OFF) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2 (FSW+) - 1 (FSW-) | Brake pedal depressed | 950 to 1050 Ω |
| Brake pedal released | 203 to 223 Ω |