46700
1. EXHAUST RETARDER ASSEMBLY
Using a vacuum pump, apply a vacuum of 53.3 to 80.0 kPa (400 to 600 mmHg) to the exhaust retarder assembly and check that the valve fully closes smoothly.
Apply the atmospheric pressure to the exhaust retarder assembly and check that the valve fully opens smoothly.
2. CHECK VALVE BODY CLEARANCE AND OPENING ANGLE
Using a vacuum pump, apply a vacuum of 86.7 to 93.3 kPa (650 to 700 mmHg) and fully close the valve.
0.2 to 0.3 mm (0.008 to 0.011 in.)
| *a | 90° |
Apply the atmospheric pressure to the exhaust retarder assembly and check the angle of the valve and body with the valve fully open.
Loosen the 2 nuts of the exhaust brake stopper bolts.
Using SST, adjust the exhaust brake valve stopper bolt protrusion while the exhaust brake valve lever is in contact with the exhaust brake valve stopper bolt (with the valve fully closed) as shown in the illustration, so that the gap between the valve and body is as specified.
Tighten the nut of the exhaust brake stopper bolt (valve fully closed side).
| *a | 90° |
Using SST, adjust the exhaust brake valve stopper bolt protrusion while the exhaust brake valve lever is in contact with the exhaust brake valve stopper bolt (with the valve fully open) as shown in the illustration, so that the angle of the valve and body is as specified.
Tighten the nut of the exhaust brake stopper bolt (valve fully open side).