Home › Engine / Hybrid System › N04C-VJ (CHARGING) › GENERATOR › from 2021.01
RM2850E _51 Engine / Hybrid System _096889 N04C-VJ CHARGING _0459685 GENERATOR G

N04C-VJ CHARGING  GENERATOR  INSPECTION  


PROCEDURE

Hide 27370 1.INSPECT GENERATOR BRUSH HOLDER ASSEMBLY

a.
A160023C01
0.646,0.698 1.125,0.875 0.479,0.177 10 false *a
*a Length


Using a vernier caliper, measure the brush length.

Standard Length:

9.5 to 11.5 mm (0.375 to 0.452 in.)


Minimum Length:

4.5 mm (0.178 in.)



If the length is less than the minimum, replace the generator brush holder assembly.

Hide 27330 2.INSPECT GENERATOR ROTOR ASSEMBLY

a.
A160024

Check that the bearing is not rough or worn.

If necessary, replace the generator rotor assembly.


b.

Check the rotor for open circuit.

i.
A160025C01
0.542,1.094 0.313,0.479 0.313,0.479 0.438,1.167 true 0.208,0.281 0.875,0.448 0.667,0.167 10 false *a 2.438,0.198 2.771,0.448 0.333,0.25 10 false *b
*a Slip Rings
*b Ohmmeter


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
Slip ring - Slip ring 20°C (60°F) 2.3 to 2.7 Ω


If the resistance is not within the standard range, replace the generator rotor assembly.



c.

Check the rotor for a short circuit.

i.
A160026C01
1.625,0.615 1.417,0.813 false 0.792,1.531 0.573,1.24 false 1.646,0.5 2.021,0.667 0.375,0.167 10 false *b 2.417,0.24 2.802,0.427 0.385,0.188 10 false *c 0.844,1.479 1.438,1.646 0.594,0.167 10 false *a
*a Slip Ring
*b Rotor Core
*c Ohmmeter


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Specified Condition
Slip ring - Rotor core 10 kΩ or higher


NOTICE:

Perform the check on the fan portion of the rotor core that has not been coated with insulation paint.


If the result is not as specified, replace the generator rotor assembly.



d.
A160027

Using a vernier caliper, measure the slip ring diameter.

Standard Diameter:

14.2 to 14.8 mm (0.560 to 0.582 in.)


Minimum Diameter:

14.0 mm (0.552 in.)


If the diameter is less than the minimum, replace the generator rotor assembly.


Hide 27310B 3.INSPECT GENERATOR DRIVE END FRAME BEARING

a.
A157277

Check that the generator drive end frame bearing is not rough or worn.

If necessary, replace the generator drive end frame bearing.