Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › MANIFOLD ABSOLUTE PRESSURE SENSOR › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0459713 MANIFOLD ABSOLUTE PRESSURE SENSOR G

N04C-VJ ENGINE CONTROL  MANIFOLD ABSOLUTE PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89420M 1.INSPECT MANIFOLD ABSOLUTE PRESSURE SENSOR

a.

Turn the ignition switch to ON.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
B104-13 (VC) - B104-14 (E2) Ignition switch ON 4.5 to 5.5 V



c.
A257922N02
1,1.49 0.583,0.896 0.583,0.896 0.448,0.896 true 0.083,0.813 0.417,1.021 0.333,0.208 10 false SST

Using a 3-way connector, connect SST (turbocharger pressure gauge) to the hose leading to the manifold absolute pressure sensor, and then measure the voltage between the terminals.

SST
09992-00242  

Standard Voltage:
Tester Connection Condition Specified Condition
B104-5 (PIM) - B104-14 (E2) When negative pressure of 40 kPa (300 mmHg) is applied 0.1 to 0.7 V
Open to atmosphere 0.8 to 1.5 V
When positive pressure of 70 kPa (0.7 kgf/cm2) is applied 1.6 to 2.3 V


HINT:

The figures above are from data measured at standard atmospheric pressure. Figures may be affected by factors such as altitude and climate. Standard atmospheric pressure is 101 kPa.

This decreases 1 kPa with every 100 m increase in altitude. Atmospheric pressure changes with the weather.