Home › Engine / Hybrid System › N04C-VJ (ENGINE CONTROL) › NITROGEN OXIDES SENSOR › from 2021.01
RM2850E _51 Engine / Hybrid System _096807 N04C-VJ ENGINE CONTROL _0459714 NITROGEN OXIDES SENSOR A

N04C-VJ ENGINE CONTROL  NITROGEN OXIDES SENSOR  INSTALLATION  


PROCEDURE

Hide 89463D 1.INSTALL NO. 2 NITROGEN OXIDES SENSOR

a.
A483629C01
0.708,1.802 0.99,1.802 0.99,1.802 1.292,0.927 true 2.26,0.469 2.479,0.646 0.219,0.177 10 true *a 0.396,1.729 0.75,1.917 0.354,0.188 10 true SST
*a Torque Wrench Fulcrum Length


Using SST, install the No. 2 nitrogen oxides sensor.

SST
09224-00012  

Torque:
Specified tightening torque : 50 N*m (510 kgf*cm, 37 ft.*lbf)

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.


HINT:
·

Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION

·

When using SST (fulcrum length of 30 mm (1.18 in.)) + torque wrench (fulcrum length of 255 mm (10.0 in.)): 44.7 N*m (456 kgf*cm, 33 ft.*lbf)




b.

Connect the No. 2 nitrogen oxides sensor with the 2 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


c.

Connect the connector to the No. 2 nitrogen oxides sensor.


d.

Attach the 3 clamps.