88410
1.INSTALL MAGNETIC CLUTCH ASSEMBLY
| *a | Screw |
| *b | Bolt |
Install the magnetic clutch starter with the 3 bolts.
7.9 N*m (81 kgf*cm, 70 in.*lbf)
Install the ground wire with the screw.
Using a snap ring expander, install the magnetic clutch rotor and a new snap ring with the chamfered side facing outward.
Do not damage the seal cover of the bearing when installing the snap ring.
Install the magnetic clutch washers and magnet clutch hub.
Do not change the combination of the magnetic clutch washers used before disassembly.
| *a | SST |
Using SST, secure the magnetic clutch hub and install the bolt.
22.6 N*m (230 kgf*cm, 17 ft.*lbf)
Make sure that there is no foreign matter or oil on the compressor shaft, bolt and clutch hub.
88410
2.INSPECT MAGNETIC CLUTCH CLEARANCE
| *1 | Magnet Clutch Hub |
| *a | Component without harness connected
(Compressor And Magnetic Clutch) |
| *b | Battery |
Clamp the compressor in a vise.
Set the dial indicator to the magnetic clutch hub.
Connect the positive battery lead to terminal 1 (MG+) of the magnetic clutch connector and the negative lead to the ground wire. Turn the magnetic clutch on and off and measure the clearance.
0.6 to 1.0 mm (0.0236 to 0.0394 in.)
If the measured value is not within the standard clearance, remove the magnetic clutch hub and adjust the clearance using a magnetic clutch washer or combination of washers.
Adjustment should be performed with 3 or less magnetic clutch washers.
Remove the compressor from the vise.
88688K
3.INSTALL COOLER COMPRESSOR BRACKET
Install the bracket with the bolt.
Connect the connector clamp.