51405A
1.REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
2.DRAIN ENGINE COOLANT
3.DISCHARGE FUEL
16028
4.DISCONNECT NO. 2 TURBO WATER PIPE SUB-ASSEMBLY AND NO. 4 WATER BY-PASS PIPE SUB-ASSEMBLY
Disconnect the connector from the exhaust fuel addition injector assembly.
When disconnecting the connector, do not strongly push or pull the connector of the exhaust fuel addition injector assembly.
Detach the clamp and disconnect the wire harness.
Remove the 2 union bolts and 2 gaskets, and then disconnect the No. 2 turbo water pipe sub-assembly and No. 4 water by-pass pipe sub-assembly from the exhaust pipe.
Remove the nut and clamp.
23811H
5.DISCONNECT NO. 1 FUEL PIPE
Remove the union bolt and gasket, and then disconnect the No. 1 fuel pipe from the fuel delivery pipe.
15613
6.REMOVE OIL FILTER ELEMENT
87378C
7.REMOVE EXHAUST PIPE
| *1 | Gasket |
Remove the 3 bolts, 3 washers and exhaust pipe from the front exhaust pipe assembly.
Remove the gasket from the front exhaust pipe assembly.
23814D
8.REMOVE FUEL DELIVERY PIPE
During work, make sure that parts are free of foreign matter and water.
Remove the bolt and fuel delivery pipe from the exhaust pipe and exhaust fuel addition injector assembly.
23710B
9.REMOVE EXHAUST FUEL ADDITION INJECTOR ASSEMBLY
During work, make sure that parts are free of foreign matter and water.
| *1 | No. 2 Nozzle Holder Clamp |
| *2 | Exhaust Fuel Addition Injector Assembly |
| *3 | O-Ring |
| *4 | Gasket |
Remove the bolt and No. 2 nozzle holder clamp from the exhaust pipe.
When disconnecting the connector or removing and installing the exhaust fuel addition injector assembly when checking and cleaning parts, make sure not to pull the wire harness, hook or push the connector with your finger or damage the connector.
Remove the exhaust fuel addition injector assembly, O-ring and gasket from the exhaust pipe.