Home › Engine / Hybrid System › N04C-VJ (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR › from 2021.01
RM2850E _51 Engine / Hybrid System _096890 N04C-VJ EMISSION CONTROL _0461598 DIFFERENTIAL PRESSURE SENSOR G

N04C-VJ EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 89480A 1.INSPECT DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

a.

Connect the GTS to the DLC3.


b.

Turn the ignition switch on.


c.

Turn the GTS on.


d.

Enter the following menus: Powertrain / Engine and ECT / Data List / DPF Differential Pressure.


e.

Slide the clip and disconnect the No. 1 air hose.


f.
A257810N02
0.896,1.656 1.146,1.656 1.146,1.656 1.365,2.073 false 0.583,1.594 1.042,1.875 0.458,0.281 10 false SST

Install SST to the differential pressure sensor assembly.

SST
09992-00242  


g.

Using SST, apply pressure to the sensor.


h.

Check the pressure value of the sensor.

OK:

Approximately the same pressure as the applied pressure is indicated.


NOTICE:

Perform the inspection within the pressure range of 0 kPa to 98 kPa.


If the result is not as specified, check the sensor circuit.


i.

Remove SST from the differential pressure sensor assembly.


j.

Connect the No. 1 air hose to the differential pressure sensor and slide the new clip to secure the hose.