Home › Engine / Hybrid System › N04C-VJ (FUEL) › SUCTION CONTROL VALVE › from 2021.01
RM2850E _51 Engine / Hybrid System _096891 N04C-VJ FUEL _0461607 SUCTION CONTROL VALVE A

N04C-VJ FUEL  SUCTION CONTROL VALVE  REMOVAL  


PROCEDURE

Hide 53712C 1.REMOVE FRONT FENDER APRON LH

a.
A146649

Remove the 6 bolts and front fender apron LH.


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Hide 23811G 4.DISCONNECT NO. 1 FUEL PIPE

a.

Remove the nut and fuel pipe clamp.


b.
A258356

Remove the union bolt and 2 gaskets, and disconnect the No. 1 fuel pipe.

NOTICE:

Be sure to prevent foreign matter or water from entering the lines.



Hide 5.CLEAN SUCTION CONTROL VALVE AND SURROUNDING AREA

a.

Clean the area around the suction control valve assembly as well as any areas that contact other parts using a brush. After that, clean the part using cleaning spray, cloth, etc.

NOTICE:
·

After cleaning with cleaning spray, do not blow air as doing so will cause any dust or sand in the surrounding area to become airborne and adhere to the cleaned area.

·

Do not allow the fuel temperature sensor connector or fuel pipe to face downward while performing this step.

·

Check that there is no dirt or foreign matter between the suction control valve assembly and fuel supply pump housing.




Hide 04226 6.REMOVE SUCTION CONTROL VALVE ASSEMBLY

NOTICE:
·

Before replacing the suction control valve assembly, be sure to clean the surrounding area.

·

When replacing the suction control valve assembly, make sure that your hands are clean and do not use gloves, etc.

·

Be sure to prevent foreign matter or water from entering the lines.



a.

Disconnect the connector from the suction control valve assembly.


b.
A258468

Using a 5 mm hexagon wrench, remove the 2 bolts, suction control valve assembly and O-ring from the supply pump assembly.

NOTICE:
·

Do not reuse the suction control valve assembly and O-ring once they have been removed.

·

Make sure that the O-ring does not remain attached to the supply pump assembly.