Home › Engine / Hybrid System › N04C-VJ (FUEL) › FUEL SENDER GAUGE ASSEMBLY › from 2021.01
RM2850E _51 Engine / Hybrid System _096891 N04C-VJ FUEL _0461610 FUEL SENDER GAUGE ASSEMBLY G

N04C-VJ FUEL  FUEL SENDER GAUGE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 83320 1.INSPECT FUEL SENDER GAUGE ASSEMBLY

a.
A399344C02
0.104,0.104 0.417,0.26 0.313,0.156 10 false *a 2.229,1.74 2.542,1.896 0.313,0.156 10 false *b
*a Component without harness connected
(Fuel Sender Gauge Assembly)
*b Battery


Check the fuel sender gauge voltage.

i.

Apply 5 V between terminals 1 (FV) and 2 (FE).

NOTICE:
·

Be careful when connecting the leads, as the fuel sender gauge assembly may be damaged if the leads are connected to the wrong terminals.

·

Do not apply more than 6 V to terminals 1 (FV) and 2 (FE).



HINT:

If a stable power supply is not available, use 4 1.2 V nickel-metal hydride batteries or equivalent.



ii.
A399345C02
0.385,2.01 0.708,2.01 false 0.688,4.385 1.021,4.385 false 0.156,0.135 0.469,0.292 0.313,0.156 10 false *a 0.583,4.313 0.74,4.51 0.156,0.198 10 false E 0.76,1.958 0.917,2.156 0.156,0.198 10 false F
*a Component without harness connected
(Fuel Sender Gauge Assembly)


Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition

*: The output voltage changes depending on the voltage applied to the terminals.

2 (FE) - 3 (FR) Float position is F (upper) 4.255 to 4.605 V*
Float position is E (lower) 0.345 to 0.695 V*


HINT:
·

Output voltage (F) = (0.851 x Voltage applied to terminals) to (0.921 x Voltage applied to terminals)

·

Output voltage (E) = (0.069 x Voltage applied to terminals) to (0.139 x Voltage applied to terminals)



If the result is not as specified, replace the fuel sender gauge assembly.