Home › Engine / Hybrid System › N04C-VJ (FUEL) › FUEL ADDITION CUT VALVE ASSEMBLY › from 2021.01
RM2850E _51 Engine / Hybrid System _096891 N04C-VJ FUEL _0461611 FUEL ADDITION CUT VALVE ASSEMBLY G

N04C-VJ FUEL  FUEL ADDITION CUT VALVE ASSEMBLY  INSPECTION  


PROCEDURE

Hide 22214B 1.INSPECT FUEL ADDITION CUT VALVE ASSEMBLY

a.
A165239C04
0.135,0.104 0.448,0.302 0.313,0.198 10 false *a
*a Component without harness connected
(Fuel Addition Cut Valve Assembly)


Disconnect the fuel addition cut valve assembly connector.

i.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
2 - Body ground 20°C (68°F) 6.8 to 9.2 Ω


HINT:

If the result is not as specified, replace the fuel addition cut valve assembly.