Home › Engine / Hybrid System › N04C-VJ (COOLING) › RADIATOR › from 2021.01
RM2850E _51 Engine / Hybrid System _096896 N04C-VJ COOLING _0462336 RADIATOR G

N04C-VJ COOLING  RADIATOR  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT RADIATOR CAP SUB-ASSEMBLY

a.
A138101

Measure the valve opening pressure.

i.

If there are water stains or foreign matter on rubber packings 1, 2 or 3, clean the parts with water and finger scouring.


ii.

Check that rubber packings 1, 2 and 3 are not deformed, cracked or swollen.


iii.

Check that rubber packings 3 and 4 are not stuck together.


iv.

Apply engine coolant to rubber packings 2 and 3 before using the radiator cap tester.


v.
A318946C03
0.281,1.698 0.448,0.969 false 1.438,0.771 2.042,0.458 false 0.188,1.76 0.5,1.917 0.313,0.156 10 false *1 1.552,1.427 1.865,1.583 0.313,0.156 10 false *b 2.135,0.344 2.448,0.5 0.313,0.156 10 false *a
*1 Radiator Cap Sub-assembly
*a Radiator Cap Tester
*b More than 30°


When using the cap tester, tilt it to more than 30 degrees.


vi.

Pump the cap tester several times, and check the maximum pressure*1.

Pumping speed:

1 pump per second.


*1: Even if the cap cannot maintain the maximum pressure it is not a defect.

Judgement Criteria:
Item Specified Condition

If the maximum pressure is less than the specified pressure for the minimum standard value, replace the radiator cap sub-assembly.

Standard value (for brand new cap) 93.3 to 122.7 kPa (0.95 to 1.25 kgf/cm2, 13.5 to 17.8 psi)
Minimum standard value (after using cap) 78.5 kPa (0.8 kgf/cm2, 11.4 psi)