1. FIN FOR BLOCKAGE
If the fins are clogged, wash them with water or a steam cleaner, then dry them with compressed air.
If the steam cleaner is too close to the core, there is a possibility of damaging the fins, so keep to the following injection distances.
| Injection Pressure
kPa (kgf/cm2, psi) |
Injection Distance
mm (in.) |
|---|---|
| 2942 to 4903
(30 to 50, 427 to 711) |
300 (11.811) |
| 4903 to 7845
(50 to 80, 711 to 1,138) |
500 (19.685) |
If the fins are bent, straighten them with a screwdriver or pliers.
Do not expose electronic components to water.