28213
1.REMOVE STARTER CLUTCH PINION
Using a snap ring pliers and screwdriver with its tip wrapped with protective tape, remove the retainer.
| *a | Protective Tape |
Remove the pinion stop nut, starter clutch pinion and starter drive spring.
28140
2.REMOVE STARTER BRUSH HOLDER ASSEMBLY
Remove the nut from terminal C.
| *a | Terminal C |
Remove the 2 through bolts and 2 screws, then pull the commutator end frame from the starter yoke assembly.
Remove the dust protector from the commutator end frame.
Using a screwdriver, hold the starter brush spring back and disconnect the 4 starter brushes from the starter brush holder assembly.
| *a | Starter Brush Spring |
| *b | Starter Brush |
Remove the starter brush holder assembly from the starter armature assembly.
28120
3.REMOVE STARTER YOKE ASSEMBLY
Remove the starter yoke assembly.
Remove the 2 rubber seals.
28160
4.REMOVE STARTER ARMATURE ASSEMBLY
Remove the starter armature assembly from the magnet starter switch assembly.
28256
5.REMOVE STARTER INTERNAL GEAR
Remove the starter plate.
Remove the starter washer.
Remove the 3 starter planetary gears.
Remove the starter internal gear.
28110
6.REMOVE STARTER DRIVE HOUSING ASSEMBLY
Remove the 2 bolts and starter drive housing assembly from the magnet starter switch assembly.
28011
7.REMOVE STARTER CLUTCH SUB-ASSEMBLY
Using a snap ring pliers, remove the snap ring.
Remove the pinion drive lever and 3 starter washers.
Remove the starter clutch sub-assembly from the magnet starter switch assembly.