The skid control ECU (brake actuator assembly) acquires steering angle sensor zero point every time the ignition switch is turned to ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores the previous zero point.
If front wheel alignment or the steering wheel position is adjusted without disconnecting the negative battery terminal, or if yaw rate and acceleration sensor zero point is not acquired after the adjustments have been completed, the skid control ECU (brake actuator assembly) detects the difference between the previous zero point and newly acquired zero point and stores this DTC to indicate a poor adjustment.
The steering angle sensor zero point malfunction warning will be canceled by turning the ignition switch off.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1290 | The steering angle sensor zero point calibration position vastly differs from the recorded value. | ·
Yaw rate and acceleration sensor zero point calibration incomplete ·
Poor adjustment of the center position of the steering wheel ·
Poor adjustment of front wheel alignment |
When replacing the skid control ECU (brake actuator assembly), perform zero point calibration and store system information (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
Perform zero point calibration of the yaw rate and acceleration sensor (Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
When the stored zero point of the yaw rate and acceleration sensor is cleared, the steering angle sensor zero point will also be cleared.
If the zero point and output value of the yaw rate and acceleration sensor (airbag ECU assembly) and the output value of the speed sensors are not normal, steering angle sensor zero point cannot be acquired normally even if the vehicle is driven straight ahead at 35 km/h (22 mph) or more.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Start the engine.
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.
Check that the centered position of the steering wheel is correctly set while driving straight ahead.
If front wheel alignment and steering position are adjusted as a result of abnormal centered position of the steering wheel, acquire the yaw rate and acceleration sensor zero point again after the adjustments are completed.
The centered position of the steering wheel is correctly set.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click hereSuspension>ALIGNMENT / HANDLING DIAGNOSIS>FRONT WHEEL ALIGNMENT (for N04C Series Engine)>ADJUSTMENT