58410
1.REMOVE ENGINE SERVICE HOLE COVER
58734B
2.REMOVE ENGINE SERVICE COVER WEATHERSTRIP REAR
58521D
3.REMOVE ENGINE SERVICE HOLE COVER MAT
58420
4.REMOVE NO. 2 ENGINE SERVICE HOLE COVER ASSEMBLY
58534A
5.REMOVE TRANSMISSION COVER MAT
33531B
6.REMOVE SHIFT AND SELECT LEVER SHAFT DUST BOOT
Remove the shift lever knob.
Remove the 4 bolts and shift and select lever support with boots.
33820B
7.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
Remove the 2 clips from the shift lever retainer.
Remove the nut and clip, and disconnect the shift cable and select cable.
Do not sway control cable and over 8° and apply load.
Remove the nut and separate the shift wire clamp from the engine service cover front panel sub-assembly.
Remove the bolt and disconnect the transmission control cable clamp.
33504F
8.REMOVE SHIFT LEVER SUB-ASSEMBLY
Remove the 4 bolts and the shift lever assembly.
58701A
9.REMOVE FRONT ENGINE SERVICE COVER PANEL SUB-ASSEMBLY
Remove the 3 bolts and the engine service cover front panel sub-assembly.
51459
10.REMOVE ENGINE SIDE COVER STAY (for TCAP Made)
Remove the 8 clips and the 2 engine side cover stays.
51441D
11.REMOVE NO. 1 ENGINE UNDER COVER (for Plastic Type)
Remove the bolts and the No. 1 engine under cover.
| Vehicle Maker | Bolts |
|---|---|
| for TCAP Made | 8 |
| except TCAP Made | 12 |
51441D
12.REMOVE NO. 1 ENGINE UNDER COVER (for Metal Type)
Remove the 6 bolts and the No. 1 engine under cover.
53711C
13.REMOVE FRONT FENDER APRON RH
Remove the 7 bolts and the front fender apron RH.
14.DRAIN ENGINE COOLANT
16206C
15.SEPARATE WATER BY-PASS PIPE SUB-ASSEMBLY
Separate the 2 water by-pass hoses
Remove the 6 bolts and separate the water by-pass pipe sub-assembly.
17113
16.REMOVE INTAKE PIPE
Loosen the hose clamp of the inlet hose.
Remove the bolt, the 2 nuts, the inlet pipe and gasket.
17271
17.REMOVE NO. 1 TURBO INSULATOR
Remove the 5 bolts and the No. 1 turbo insulator.
25608
18.REMOVE EGR COOLER SUB-ASSEMBLY
Disconnect the water by-pass hose.
Disconnect the 3 water by-pass hoses.
Disengage the harness clamp.
Remove the 2 bolts and harness bracket.
Remove the 4 bolts, EGR cooler sub-assembly and 2 gaskets.
17341F
19.SEPARATE NO. 1 AIR HOSE
Remove the bolt from the No. 1 air hose.
Loosen the hose clamp and separate the No. 1 air hose from the turbocharger.
44773D
20.DISCONNECT SOLENOIDO TO RETARDER HOSE
Disconnect the solenoid to retarder hose.
17410
21.REMOVE FRONT EXHAUST PIPE ASSEMBLY
Remove the 3 nuts.
Remove the bolt and separate the pipe clamp.
Remove the 4 bolts, the front exhaust pipe assembly and the exhaust retarder.
Remove the 2 gaskets from the exhaust retarder.
Remove the gasket from the front exhaust pipe.
17291
22.REMOVE TURBINE OUTLET ELBOW
Remove the 2 bolts, 3 nuts, 3 spacers, outlet elbow and gasket.
16028
23.REMOVE NO. 2 TURBO WATER PIPE SUB-ASSEMBLY
Remove the bolt, union bolt, No. 2 turbo water pipe and 2 gaskets.
Remove the O-ring from the No. 2 turbo water pipe.
15407
24.REMOVE TURBO OIL INLET PIPE
Remove the bolt, 2 union bolts, turbo oil inlet pipe and 4 gaskets.
16027
25.REMOVE NO. 1 TURBO WATER PIPE SUB-ASSEMBLY
Remove the nut and the water by-pass pipe support.
Remove the 2 union bolts, No. 1 water by-pass pipe and 4 gaskets.
15474
26.REMOVE TURBO OIL OUTLET PIPE
Remove the 4 bolts, turbo oil outlet pipe and 2 gaskets.
17201
27.REMOVE TURBOCHARGER SUB-ASSEMBLY
Disconnect the connector from the turbocharger.
Remove the 4 nuts, 4 spacers, turbocharger sub-assembly and gasket.
Remove the 7 stud bolts.