To avoid the danger of being burned, do not remove the radiator cap while the engine and radiator are still hot. Thermal expansion will cause hot engine coolant and steam to blow out from the radiator.
Remove the service hole cover from the engine under cover.
Install a vinyl hose onto the drain on the radiator side.
Fix the vinyl hose with tape.
Loosen the 3 drain plugs on the engine and radiator, and drain the coolant.
Remove the radiator cap.
Drain the coolant from the reservoir tank.
Tighten the 3 drain plugs.
Torque:
13 N*m{
130 kgf*cm
, 9 ft.*lbf
}
for the engine
Remove the vinyl hose from the radiator.
3.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
4.
REMOVE V-BANK COVER
Remove the 2 nuts, then remove the V-bank cover.
5.
REMOVE AIR CLEANER ASSEMBLY
Disconnect the No. 2 ventilation hose.
Disconnect the vacuum hose.
Disconnect the mass air flow meter connector.
Disengage the 2 wire harness clamps.
Loosen the 2 hose clamps.
Remove the 2 bolts.
Disconnect the air cleaner hose and remove the air cleaner.
6.
REMOVE THROTTLE BODY BRACKET
Remove the 2 bolts and the throttle body bracket.
7.
REMOVE OIL BAFFLE PLATE
Remove the bolt and the oil baffle plate.
8.
REMOVE NO. 1 SURGE TANK STAY
Remove the 2 bolts and the No. 1 surge tank stay.
9.
REMOVE NO. 2 SURGE TANK STAY
Remove the 2 bolts and the No. 2 surge tank stay.
10.
REMOVE INTAKE AIR SURGE TANK
Disconnect the 2 water by-pass hoses.
Disconnect the fuel vapor feed hose.
Disconnect the ventilation hose.
Disconnect the 2 VSV connectors.
Disconnect the throttle body with motor connector.
Separate the 3 wire harness clamps and the hose clamp.
Remove the 2 nuts.
Using a socket hexagon wrench 8, remove the 4 bolts, intake air surge tank and the gasket.
11.
DISCONNECT NO. 2 FUEL PIPE SUB-ASSEMBLY
Remove the No. 2 fuel pipe clamp.
Pinch the tube connector, and then pull the fuel pipe out of the delivery pipe as shown in the illustration.
NOTICE:
Remove any dirt and foreign objects from the fuel tube connector before performing this work.
Do not allow any scratches or foreign objects on the parts when disconnecting, as the fuel tube connector has the O-ring that seals the pipe.
Perform this work by hand. Do not use any tools.
Do not forcibly bend, twist or turn the nylon tube.
Protect the disconnected part by covering it with a vinyl bag after disconnecting the fuel tube.
If the fuel tube connector and pipe are stuck, push and pull to release them.
12.
REMOVE ENGINE COOLANT TEMPERATURE SENSOR
Disconnect the connector.
Using a 19 mm deep socket wrench, remove the water temperature sensor and gasket.