2011-2016 FJ Cruiser · Service Manual HEATER & AIR CONDITIONING SYSTEM

REMOVAL

Removal / installation · Vehicles built Jul 2007 – Jul 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. DISCHARGE REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Switch A/C ON.

  1. Turn the blower switch to ON.

  1. Operate the cooler compressor with an engine speed of approximately 1,000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

  1. Stop the engine.

  1. Remove the caps from the service valves on the refrigerant line.

    I104027E01

  1. Connect the refrigerant recovery unit.

  1. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

    NOTICE:
    Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.


2. REMOVE BATTERY HOLD DOWN CLAMP

3. REMOVE BATTERY

4. REMOVE BATTERY TRAY

5. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY
  1. Remove the 4 bolts, then remove the No. 1 engine under cover.


6. REMOVE FAN & GENERATOR V BELT

A076441E01
  1. While releasing the belt tension by turning the belt tensioner counterclockwise, remove the V-ribbed belt from the belt tensioner.


7. REMOVE FRONT FENDER APRON UPPER SEAL

I104023
  1. Using a clip remover, disengage the 5 clips and remove the front fender apron upper seal.


8. DISCONNECT NO. 2 ENGINE WIRE

I104024
  1. Disengage the 3 clamps and separate the No. 2 engine wire.


9. DISCONNECT DISCHARGE HOSE SUB-ASSEMBLY

I104012
  1. Remove the nut and disconnect the discharge hose.

  1. Remove the O-ring from the discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


10. DISCONNECT SUCTION HOSE SUB-ASSEMBLY

I104013
  1. Remove the bolt and separate the suction hose.

  1. Remove the nut and disconnect the suction hose.

  1. Remove the O-ring from the suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering.


11. REMOVE COOLER COMPRESSOR ASSEMBLY

I104014
  1. Disconnect the connector.

  1. Remove the 4 bolts and compressor.

← COMPONENTS (from Nov 2010)REMOVAL (from Aug 2009) →