Read "PRECAUTION" thoroughly before servicing (Click here).
2.
INSTALL STEERING PAD
Support the steering pad with one hand as shown in the illustration.
Connect the 2 connectors to the steering pad.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
Connect the horn connector.
Confirm that the circumferencial groove of the "Torx" screw fits in the screw case, and place the steering pad onto the steering wheel assembly.
Using "Torx" socket wrench (T30), tighten the 2 "Torx" screws.
Torque:
8.8 N*m{
90 kgf*cm
, 78 in.*lbf
}
NOTICE:
Tighten the 2 bolts while holding the steering pad to prevent it from moving upward.
3.
INSTALL STEERING WHEEL COVER LOWER NO.3
Install steering wheel cover lower No.3.
4.
INSTALL STEERING WHEEL COVER LOWER NO.2
Install steering wheel cover lower No.2.
5.
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Torque:
3.9 N*m{
40 kgf*cm
, 35 in.*lbf
}
6.
INSPECT STEERING PAD
With the steering pad installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the steering pad with a new one:
Cuts, minute cracks or marked discoloration on the steering pad top surface or in the grooved portion.
Make sure that the horn sounds.
HINT:
If the horn does not sound, inspect the horn system (Click here).