REMOVAL
Removal / installation · Vehicles built Nov 2010 – Jul 2012
Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012
| 1.
PRECAUTION |
 |
- CAUTION:
- Read "PRECAUTION" thoroughly before servicing (Click here).
| 2.
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL |
 |
- CAUTION:
- Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.
| 3.
REMOVE STEERING WHEEL COVER LOWER NO.3 |
 |
- Using a thin-bladed screwdriver, remove steering wheel cover lower No.3.
- HINT:
- Tape up the screwdriver tip before use.
| 4.
REMOVE STEERING WHEEL COVER LOWER NO.2 |
 |
- Using a thin-bladed screwdriver, remove steering wheel cover lower No.2.
- HINT:
- Tape up the screwdriver tip before use.
| 5.
REMOVE STEERING PAD |
 |
- Using "Torx" socket wrench (T30), loosen the 2 "Torx" screws until the groove along the screw circumference catches on the screw case.
- Pull the steering pad out of the steering wheel assembly and support the steering pad with one hand as shown in the illustration.
- NOTICE:
- When removing the steering pad, do not pull the airbag wire harness.
Disconnect the horn connector.
Disconnect the 2 connectors from the steering pad.
- NOTICE:
- When handling the airbag connector, take care not to damage the airbag wire harness.
Remove the steering pad.