2011-2016 FJ Cruiser · Service Manual RESTRAINTS

REMOVAL

Removal / installation · Vehicles built from Aug 2012

Versions by build date: Jul 2007 – Oct 2010 Nov 2010 – Jul 2012 from Aug 2012


1. PRECAUTION

CAUTION:
Read "PRECAUTION" thoroughly before servicing (Click here).


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.


3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

4. REMOVE STEERING WHEEL COVER LOWER NO.3

  1. C128195
    Using a thin-bladed screwdriver, remove steering wheel cover lower No.3.

    HINT:
    Tape up the screwdriver tip before use.


5. REMOVE STEERING WHEEL COVER LOWER NO.2

  1. C128196
    Using a thin-bladed screwdriver, remove steering wheel cover lower No.2.

    HINT:
    Tape up the screwdriver tip before use.


6. REMOVE STEERING PAD

  1. C128197E01
    Using "Torx" socket wrench (T30), loosen the 2 "Torx" screws until the groove along the screw circumference catches on the screw case.

  1. C128193E01
    Pull the steering pad out of the steering wheel assembly and support the steering pad with one hand as shown in the illustration.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector.

  1. Disconnect the 2 connectors from the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. Remove the steering pad.


7. REMOVE STEERING WHEEL ASSEMBLY

C133806E03
Text in Illustration 
*a
Matchmark
*b
Hold
*c
Turn
  1. Remove the steering wheel assembly set nut.

  1. Put matchmarks on the steering wheel assembly and the main shaft assembly.

  1. Using SST, remove the steering wheel assembly.

    SST
    09950-50013   (09951-05010, 09952-05010, 09953-05020, 09954-05021)

    NOTICE:
    Apply a small amount of grease to the threads and tip of SST (center bolt) before use.


8. REMOVE LOWER STEERING COLUMN COVER

C234531
  1. Remove the 3 screws.

  1. Disengage the 2 claws and remove the lower steering column cover.


9. REMOVE UPPER STEERING COLUMN COVER

C231841
  1. Disengage the claw and remove the upper steering column cover.


10. REMOVE SPIRAL CABLE

  1. B108276E01
    Disconnect the connectors from the spiral cable.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.

  1. C128206
    Disengage the 4 screws and remove the spiral cable.

← REMOVAL (Nov 2010 – Jul 2012)INSPECTION (from Jul 2007) →