2011-2016 FJ Cruiser · Service Manual RESTRAINTS

CHECK MODE PROCEDURE

Troubleshooting · Vehicles built from Jul 2007


CHECK MODE (SIGNAL CHECK): DTC CHECK
  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Select "SIGNAL CHECK", and proceed with checking using the tester.

    NOTICE:
    Select "SIGNAL CHECK" from the "DTC CHECK" screen displayed on the tester to clear the output DTCs (both present and past).

    HINT:
    1. DTCs can be detected more sensitively in check mode than in normal diagnosis mode.
    2. Perform the check mode inspection when a malfunction in each squib circuit is suspected even after the normal system code is output through the normal diagnosis mode inspection.

← DTC CHECK / CLEAR (from Aug 2011)DATA LIST / ACTIVE TEST (from Jul 2007) →