2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

DATA LIST / ACTIVE TEST

System information · Vehicles built from Jul 2007


READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under Normal Condition are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body / Data List.

  5. According to the display on the intelligent tester, read the Data List.

    Main Body 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Key Unlock Warning SW
    Unlock warning switch / ON or OFF
    ON: Ignition key is inserted
    OFF: Ignition key is not inserted
    -
    Luggage Courtesy SW
    Back door and back window courtesy switch signal/ON or OFF
    ON: Either back door or back window open
    OFF: Both the back door and back window are closed
    -
    D Door Courtesy SW
    Driver door courtesy switch signal/ON or OFF
    ON :Driver door open
    OFF: Driver door closed
    -
    P Door Courtesy SW
    Front passenger door courtesy switch signal/ON or OFF
    ON: Front passenger door open
    OFF: Front passenger door closed
    -
    Rear Door Courtesy SW
    Rear door courtesy switch signal/ON or OFF
    ON: Either right or left rear door open
    OFF: Both the right and left rear doors are closed
    -


PERFORM ACTIVE TEST

HINT:
Using the intelligent tester to perform Active Tests allows relays, VSVs, actuators and parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing the Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be display while performing Active Test.

  1. Connect the intelligent tester to the DLC3.

  2. Turn the ignition switch to ON.

  3. Turn the intelligent tester on.

  4. Enter the following menus: Body / Main Body ECU/ Active Test.

  5. According to the display on the intelligent tester, perform the Active Test.

    Main Body 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Hazard
    Turns turn signal flasher relay ON/OFF
    ON/OFF
    -
    Wireless Buzzer (Continuous Sound)*1
    Wireless door lock buzzer (continuous) ON/OFF
    ON/OFF
    -
    Wireless Buzzer*1
    Wireless door lock buzzer ON/OFF
    ON/OFF
    -
    1. *1: w/ Wireless door lock buzzer

← DTC CHECK / CLEAR (from Jul 2007)ON-VEHICLE INSPECTION (Jul 2007 – Oct 2010) →