Disconnect the 2 purge line hoses from the canister.
Disconnect the air inlet line hose from the canister.
Remove the canister from the bracket.
3.
DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY
Disconnect the pipe from the clamp.
Pinch and pull the fuel pipe connector to disconnect it from the fuel filter upper pipe.
NOTICE:
Check that there is no dirt or mud around the quick connector before performing this work because the quick connector has an O-ring which seals the pipe and the connector. Clean the connector if necessary.
Do not use any tools in this work.
Do not bend or twist the nylon tube.
To protect the tube, cover it with a vinyl bag after disconnecting it.
When the connector and the pipe are stuck, turn the retainer carefully to disconnect them.
4.
REMOVE FUEL MAIN TUBE
Remove the fuel tube grommet.
Detach the lock claws by lifting up the connector cover. Then pinch and pull the fuel main tube connector to disconnect it from the fuel filter lower pipe.
NOTICE:
Check that there is no dirt or mud around the quick connector before performing this work because the quick connector has an O-ring which seals the pipe and the connector. Clean the connector if necessary.
Do not use any tools in this work.
Do not bend or twist the nylon tube.
To protect the tube, cover it with a vinyl bag after disconnecting it.
When the connector and the pipe are stuck, turn the retainer carefully to disconnect them.
5.
REMOVE FUEL FILTER
Disconnect the charcoal canister from the bracket.