2011-2016 FJ Cruiser · Service Manual BODY ELECTRICAL

Radio Receiver Power Source Circuit

Circuit diagnosis · Vehicles built from Nov 2010

Versions by build date: Jul 2007 – Oct 2010 from Nov 2010

DESCRIPTION

This circuit provides power to the radio receiver assembly.

WIRING DIAGRAM

E219926E01

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. INSPECT HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY - BODY GROUND AND BATTERY)

  1. E219927E01
    Disconnect the E85*1 or E41*2 radio receiver assembly connector.*1: for 10 Speaker with Sub-Woofer*2: for 6 Speaker

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (for 10 Speaker with Sub-Woofer):
    Tester Connection
    Condition
    Specified Condition
    E85-20 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Resistance (for 6 Speaker):
    Tester Connection
    Condition
    Specified Condition
    E41-7 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage (for 10 Speaker with Sub-Woofer):
    Tester Connection
    Switch Condition
    Specified Condition
    E85-1 (B) - E85-20 (GND)
    Always
    11 to 14 V
    E85-11 (ACC) - E85-20 (GND)
    Ignition switch ACC
    11 to 14 V

    Standard Voltage (for 6 Speaker):
    Tester Connection
    Switch Condition
    Specified Condition
    E41-4 (B) - E41-7 (GND)
    Always
    11 to 14 V
    E41-3 (ACC) - E41-7 (GND)
    Ignition switch ACC
    11 to 14 V

    Text in Illustration 
    *a
    Front view of wire harness connector
    (to Radio Receiver Assembly (for 10 Speaker with Sub-Woofer))
    *b
    Front view of wire harness connector
    (to Radio Receiver Assembly (for 6 Speaker))



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Radio Receiver Power Source Circuit (Jul 2007 – Oct 2010)Stereo Component Amplifier Power Source Circuit (from Nov 2010) →