TERMINALS OF ECU
System information · Vehicles built from Jul 2007
| CLOCK ASSEMBLY |


Disconnect the clock assembly connector.
Measure the voltage of the wire harness side connector.
If the result is not as specified, there may be a malfunction on the wire harness side.Standard voltage: Symbols (Terminal No.)
Wiring Color
Terminal Description
Condition
Specified Condition
ILL+ (F2-3) - Body ground
G - Body ground
Illumination Signal
Combination switch OFF
Below 1 V
Combination switch Head
11 to 14 V
ACC (F2-4) - Body ground
GR - Body ground
Ignition Switch Signal
Ignition switch OFF
Below 1 V
Ignition switch ON
11 to 14 V
E (F2-2) - Body ground
W-B - Body ground
Ground
Always
Below 1 V
B (F2-1) - Body ground
R - Body ground
Battery
Always
11 to 14 V