2011-2016 FJ Cruiser · Service Manual BODY

TERMINALS OF ECU

System information · Vehicles built from Jul 2007


CHECK BACK DOOR ECU
B062706E02
  1. Measure the voltages of the wire harness side connectors.

    Standard voltage: 
    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    S2-5 (BECU) - S2-3 (GND)
    W-R - W-B
    ECU power supply (from battery)
    Always
    11 to 14 V
    S2-3 (GND) - Body ground
    W-B - Body ground
    Ground circuit
    Always
    Below 1 V
    S5-5 (L) - S5-19 (E)
    L - V-G
    Back door lock key cylinder lock signal (Back window unlock signal)
    Back door lock key cylinder lock OFF
    11 to 14 V
    Back door lock key cylinder lock ON (LOCK)
    Below 1 V
    S5-13 (GHC+) - S2-3 (GND)
    L-Y - W-B
    Back window unlock operation signal
    Back door lock key cylinder lock OFF
    Below 1 V
    Back door lock key cylinder lock ON (LOCK) for 0.8 seconds or more
    11 to 14 V → Below 1 V
    S5-12 (P) - S5-19 (E)
    P-B - V-G
    Rear wiper housing position switch signal
    Ignition switch ON and wiper switch OFF
    Below 1 V
    If the result is not as specified, there may be a malfunction on the wire harness side.

← PROBLEM SYMPTOMS TABLE (from Jul 2007)COMPONENTS (from Jul 2007) →