2011-2016 FJ Cruiser · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }


3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

F051848E01

NOTICE:
Some fluid will remain in the oil pan.

  1. Remove the 20 bolts and the oil pan.

  1. AT00103E01
    Examine the particles in the pan.

    1. Remove the magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bushing wear


4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

D028692E01
  1. Remove the 4 bolts and the oil strainer.

    NOTICE:
    Be careful as some fluid will come out of the oil strainer.


5. SEPARATE TRANSMISSION WIRE

D028693E01
  1. Remove the 2 bolts and 2 clamps.

  1. Disconnect the ATF temperature sensor.

  1. Disconnect the 7 connectors from the solenoid valves.


6. REMOVE TRANSMISSION WIRE

C113707
  1. Disconnect the transmission wire connector.

  1. Remove the bolt and pull out the transmission wire.

← COMPONENTS (from Jul 2007)INSPECTION (from Jul 2007) →