2011-2016 FJ Cruiser · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DRAIN AUTOMATIC TRANSMISSION FLUID
  1. Remove the drain plug and gasket, and drain ATF.

  1. Install a new gasket and the drain plug.

    Torque:
    20 N*m{ 204 kgf*cm , 15 ft.*lbf }


3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

F051848E01

NOTICE:
Some fluid will remain in the oil pan.

  1. Remove the 20 bolts and oil pan.

  1. AT00103E01
    Examine the particles in the oil pan.

    1. Remove all the magnets and use them to collect steel particles. Carefully look at the foreign matter and particles in the pan and on the magnets to determine the type of wear you will find in the transmission.
      Steel (magnetic): bearing, gear and clutch plate wear
      Brass (non-magnetic): bushing wear


4. REMOVE VALVE BODY OIL STRAINER ASSEMBLY

D028692E01
  1. Remove the 4 bolts and oil strainer.

    NOTICE:
    Be careful as some fluid may leak out of the oil strainer.


5. DISCONNECT TRANSMISSION WIRE

D028693E01
  1. Remove the 2 bolts and 2 clamps.

  1. Disconnect the ATF temperature sensor.

  1. Disconnect the 7 connectors from the solenoid valves.


6. REMOVE TRANSMISSION VALVE BODY ASSEMBLY

D028694E01
  1. Remove the 19 bolts and valve body.

  1. Remove the 3 drum seal gaskets.

← COMPONENTS (from Jul 2007)DISASSEMBLY (from Jul 2007) →