2011-2016 FJ Cruiser · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Jul 2007


1. INSTALL FRONT OIL PUMP OIL SEAL

D027961E01
  1. Using SST and a hammer, install a new oil seal.

    SST
    09350-30020   (09351-32140)

    HINT:
    The oil seal end should be flush with the outer edge of the pump body.

  1. Coat the oil seal lip with MP grease.


2. FIX FRONT OIL PUMP BODY SUB-ASSEMBLY
  1. Place the oil pump body on the torque converter clutch.


3. INSTALL FRONT OIL PUMP DRIVEN GEAR

D027959E01
  1. Coat the driven gear with Toyota Genuine ATF WS or equivalent.

  1. Install the driven gear onto the oil pump body.


4. INSTALL FRONT OIL PUMP DRIVE GEAR

D027958E01
  1. Coat the drive gear with Toyota Genuine ATF WS or equivalent.

  1. Install the drive gear onto the oil pump body.


5. INSTALL FRONT OIL PUMP BODY O-RING

D027963E01
  1. Install a new O-ring onto the oil pump body.


6. INSTALL STATOR SHAFT ASSEMBLY

D027953E01
  1. Align the bolt holes of the stator shaft and oil pump body and install the stator shaft.

  1. Install the 14 bolts.

    Torque:
    12 N*m{ 122 kgf*cm , 9 ft.*lbf }


7. INSTALL CLUTCH DRUM OIL SEAL RING

D027952E03
  1. Coat the 3 oil seal rings with Toyota Genuine ATF WS or equivalent.

  1. Put together the ends of the 3 oil seal rings together with the overlap distance 8 mm (0.314 in.) or less, and then install them onto the stator shaft groove.

    NOTICE:
    Do not over-widen the ring ends.

    HINT:
    After installing the oil seal rings, check that they rotate smoothly.


8. INSPECT OIL PUMP DRIVE GEAR ROTATION

D027962E01
  1. Make sure the drive gear rotates smoothly.

  1. Remove the oil pump assembly from the torque converter.


9. INSTALL FRONT OIL PUMP BODY O-RING

D027950E01
  1. Install a new O-ring onto the oil pump assembly.

← INSPECTION (from Jul 2007)COMPONENTS (from Jul 2007) →