DISPOSAL
Removal / installation · Vehicles built from Jul 2007
| 1. DISPOSE OF FRONT SHOCK ABSORBER ASSEMBLY |
![]() ![]() |
Fully extend the shock absorber piston rod, and fix it at an angle in a vise or similar tool.
Using a drill or similar tool, slowly make a hole at approximately 50 mm (1.97 in.) from the top end of the shock absorber, and discharge the gas inside.
- CAUTION:
- The gas is colorless, odorless and harmless.
- Since the discharged gas may cause chips to scatter, cover the drill with a shop rag or piece of cloth when making the hole.
- The gas is colorless, odorless and harmless.


