2011-2016 FJ Cruiser · Service Manual SUSPENSION & AXLE

REMOVAL

Removal / installation · Vehicles built from Jul 2007


1. REMOVE FRONT WHEELS

2. REMOVE ENGINE UNDER COVER SUB-ASSEMBLY

3. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH

C099158
  1. Remove the nut and separate the stabilizer link from the steering knuckle.

    HINT:
    If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud.


4. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:
The removal procedure for the RH side is the same as that for the LH side.


5. REMOVE FRONT STABILIZER BAR

G020162
  1. Remove the 4 bolts and 2 stabilizer brackets and remove the stabilizer bar.


6. SEPARATE TIE ROD END SUB-ASSEMBLY
  1. Remove the cotter pin and nut.

  1. F051679E01
    Using SST, separate the tie rod end from the steering knuckle.
    SST
    09628-62011  


7. REMOVE FRONT SHOCK ABSORBER WITH COIL SPRING

C099159
  1. Remove the bolt, nut and washer.

  1. C099160
    Remove the 3 nuts on the upper side of the front shock absorber with coil spring.

  1. Remove the front shock absorber with coil spring.

← COMPONENTS (from Jul 2007)DISASSEMBLY (from Jul 2007) →