REMOVAL
Removal / installation · Vehicles built from Jul 2007
| 2.
INSPECT FRONT UPPER SUSPENSION ARM |
 |
Check that there is no slack on the ball joint by shaking the upper arm up and down by hand.
| 3.
SEPARATE SKID CONTROL SENSOR WIRE |
 |
Remove the 2 bolts and separate the skid control sensor wire.
| 4.
REMOVE FRONT UPPER SUSPENSION ARM |
 |
Support the lower arm with a jack.
Remove the clip and nut.
- Using SST, separate the upper ball joint from the steering knuckle.
- SST
- 09628-62011
- Remove the bolt and separate the bracket.
- Remove the bolt, 2 washers and nut.
Remove the upper arm.