2011-2016 FJ Cruiser · Service Manual HEATER & AIR CONDITIONING SYSTEM

REASSEMBLY

Removal / installation · Vehicles built from Aug 2009

Versions by build date: Jul 2007 – Jul 2009 from Aug 2009


1. INSTALL MAGNET CLUTCH ASSEMBLY

E065508
  1. Install the magnet clutch stator with the parts shown in the illustration matched.

  1. I032461
    Using a snap ring expander, install a new snap ring with the chamfered side facing up.

  1. Connect the connector.

  1. I031582
    Using SST, install the magnet clutch rotor and a new snap ring with the chamfered side facing up.

    NOTICE:
    Do not damage the seal cover of the bearing when installing the snap ring.

  1. Install the compressor spacer and magnet clutch hub.

    NOTICE:
    Do not change the combination of the compressor spacer used before disassembly.

  1. I105071E01
    Using SST, hold the magnet clutch hub and install the bolt.
    SST
    09985-00260  

    Torque:
    18 N*m{ 184 kgf*cm , 13 ft.*lbf }

    NOTICE:
    Make sure that there is no foreign matter or oil on the compressor shaft, bolt, and clutch hub.


2. INSTALL COOLER BRACKET

I105068
  1. Install the cooler bracket with the screw.


3. INSPECT MAGNET CLUTCH CLEARANCE

I105420E01
  1. Clamp the cooler compressor in a vise.

  1. Set the dial indicator to the magnet clutch hub.

  1. Connect the battery positive lead to terminal 3 (MG+) of the magnet clutch connector and the negative lead to the ground wire. Turn the magnet clutch on and off and measure the clearance.

    Standard clearance:
    0.35 to 0.60 mm (0.014 to 0.024 in.)

    If the measured value is not within the standard clearance, remove the magnet clutch hub and adjust the clearance using compressor spacer to obtain the standard clearance.

    Compressor spacer thickness:
    0.1 mm (0.004 in.)
    0.3 mm (0.012 in.)
    0.5 mm (0.020 in.)

    NOTICE:
    Adjustment should be performed with 3 or less magnet clutch washers.

    Text in Illustration 
    *1
    Battery
    *a
    Components without harness connected:
    (Magnet clutch)

  1. Remove the cooler compressor from the vise.

← REASSEMBLY (Jul 2007 – Jul 2009)INSTALLATION (Jul 2007 – Jul 2009) →